Posted by: Roy Duggan
Always get 100% Packet Loss at end node - 05/12/17 08:21 AM
I am trying to monitor latency out to service we use on Amazons EC2 infrastructure, I know that many of the nodes at the far end dont / or rarely respond to pings, but the end node allways shows 100% so actual ping times are hidden under a blanket red bar
see https://share.pingplotter.com/UjXGmiarvpc
I had tried to bring back tracing to one node prior to end point but each time i do this the last node allways reports 100% loss.....
Can I set the disply to ignore packet loss?
see https://share.pingplotter.com/UjXGmiarvpc
I had tried to bring back tracing to one node prior to end point but each time i do this the last node allways reports 100% loss.....
Can I set the disply to ignore packet loss?